Standing water in the tub usually comes from a clogged filter, a kinked drain hose, a blocked garbage disposal inlet, or a drain pump that has failed or is jammed with glass or a fruit pit.
Check first: Take out the bottom rack and clean the filter under the spray arm. Run the garbage disposal for a few seconds, then look under the sink for a drain hose that is kinked or pinched. On a new install, the disposal knockout plug may still be in place. If the dishwasher drains through a garbage disposal, a jammed or new garbage disposal is often the cause. Our dishwasher not draining guide walks through more checks.
Dirty dishes after a full cycle often mean clogged spray arms, a dirty filter, a weak circulation pump, or water that isn't hot enough. A dishwasher that doesn't fill all the way has the same effect.
Check first: Run the hot water at the kitchen sink until it is hot before you start a cycle. Pull the spray arms off and rinse out any holes blocked with food or scale. Cloudy glasses and white film usually point to hard water; our guide to hard water and dishwashers explains what helps.
Leaks come from a worn door gasket, a loose hose clamp at the pump, a cracked water inlet valve, a dishwasher that isn't level, or too many suds from the wrong detergent.
Check first: Wipe the door gasket and look for tears or food stuck to it. Use only detergent made for dishwashers. With the power off, remove the kick plate and look underneath with a flashlight to see where the water starts. More in our article on a leaking dishwasher.
Most often it is the door latch or door switch, a control lock that was turned on by accident, a blown thermal fuse, or a control board fault. A tripped breaker or GFCI outlet can look the same.
Check first: Close the door firmly until the latch clicks. Check whether the control lock is on; the owner's manual shows which button releases it. Then check the breaker and any GFCI outlet under the sink. If you have an LG, see what to do when an LG dishwasher won't turn on.
On models with a heating element, wet dishes usually mean the element, its thermostat, or the control has failed. Many newer dishwashers dry by condensation and have no element, so plastics stay damp even when nothing is wrong.
Check first: Fill the rinse aid dispenser; without rinse aid, condensation drying works poorly. Open the door a few inches at the end of the cycle to let steam out. If glass and metal dishes are still wet on a model with a heating element, the element likely needs testing.
Error codes, buttons that don't respond, or a blank display usually point to a sensor, a flood switch that has tripped, a wiring fault, or the control board.
Check first: Write down the code, then turn the dishwasher off at the breaker for one minute and turn it back on. If the code comes back, it tells us where to start. On an LG, our guide to LG dishwasher error codes explains what each code means.
Turn off the power at the breaker before you remove the kick plate or any panel. If these checks don't solve it, book a diagnostic and we'll find the part that actually failed.
| Common repair | Typical cost |
|---|---|
| Not draining (pump, filter, or hose) | $210 to $360 |
| Water leak | $230 to $400 |
| Not cleaning well | $200 to $360 |
| Error code or control board | $270 to $480 |
Typical repair cost in Los Angeles; exact price after the $65 diagnostic, which goes toward the repair.
In many cases, yes, especially for built-in, panel-ready, and premium models, where a new dishwasher also means new panels and installation. Dishwashers have a short life, so check our repair or replace guide before a big repair. It explains the 50% rule: if a repair costs more than half the price of a comparable new dishwasher and yours is near the end of its life, replacing it usually makes more sense.
Wondering what other repairs cost? See the typical prices in our dishwasher repair cost guide.
Got a new dishwasher? We also handle dishwasher installation.
“Very quick response, solved the problem with a Maytag dishwasher immediately and charged me a very reasonable price.”
“I used Stan for my dishwasher that was leaking water and hissing from underneath. […] he came over the next day. Fixed and out in 30 minutes.”
“Figured the problem in ten minutes”
Read more on our reviews page.