Electrolux Appliance Repair in Los Angeles

Electrolux washer flashing E21? Wall oven stuck on F10? We come out and fix Electrolux all over LA: front-loaders, dryers, French-door fridges, those tall fridge and freezer columns, wall ovens, ranges, induction cooktops, dishwashers. Even the old ICON stuff. Electrolux is the parent company of Frigidaire, and if you pull the panels off you'll find plenty of the same parts in both. Handy for us, and usually for you too.

$65 diagnostic applied toward an approved repair • Clear estimate before work begins • 183-day parts and labor warranty.

Call us before 11 a.m. and same-day is often doable. Pumps, door locks, igniters, oven sensors, that kind of thing is usually somewhere in town. If a part has to ship, you hear how long before you say yes.

Good news with Electrolux: it tells you a lot. A front-loader showing E11 took too long to fill. E21? Water's not draining fast enough. E35 is the pressure sensor saying there's too much water in there, and E41 means the board thinks the door's open even when it's shut. Dishwashers use i-codes instead: i10 for low fill, i20 for a clogged filter or a restricted drain, i30 when water's sitting in the base pan. On wall ovens you'll mostly see F10, oven too hot, or F30, the temp sensor circuit reading open.

We don't just swap whatever part the code points at. An E21 first gets the pump filter and the drain hose. An i20, the filters at the bottom of the tub. Fridges mostly stay quiet, no codes, so there we're reading temperatures, looking at where the frost is, listening to the fans. Nothing gets replaced until it fails on the meter.

• We read the code before we open the panels
• You talk to the technician doing the work
• $65 diagnostic, applied toward the repair if you go ahead
• Written estimate before any work starts
• Parts matched to your full model number
• Shoe covers and floor protection
• Licensed in California, License A 50129
• 183-day warranty on parts and labor for completed repairs

Same tech does Electrolux and Frigidaire. Lots of shared parts.

Pumps, door locks, sensors, igniters, elements, fans, inlet valves. That's most of what fails on an Electrolux, and fixing it nearly always makes sense.

Where we'd slow down: an older fridge with a sealed-system leak, an older front-loader that wants a new motor control board, an ICON part that's out of production. We'll show you what failed and what the fix costs. Then you decide, no pressure either way.

No, we're an independent company. Electrolux and Frigidaire haven't authorized us, and we have no affiliation with them. Still covered by the Electrolux warranty? Then go through them first.

It means the water's draining too slowly. Before calling anyone, look behind the washer: a kinked drain hose, or one stuffed too far down the standpipe, causes this a lot. The pump filter sits behind the little door at the bottom front, so clean that too. If E21 comes right back, the pump or the wiring to it is next on our list.

Electrolux's manual calls i20 clogged filters or a restricted drain. Pull the filters out of the tub floor, rinse them under the tap, and wipe out the sump. Then check under the sink that the drain hose hasn't kinked. If the code keeps coming back after that, it's time for us.

$65, and it comes off the bill if you go ahead with the repair. The written estimate comes before any work.

We do. Electrolux owns Frigidaire, and plenty of parts and designs are the same between them.

Often, yes, if you call before 11 AM. Small fixes sometimes get done on that first visit. If a part has to be ordered, we order it after the diagnostic and come back when it lands.