The usual causes are dusty condenser coils, a condenser or evaporator fan that has stopped, a failed start relay, or a control board fault. Less often it is the compressor or a refrigerant leak in the sealed system.
Check first: Make sure the temperature dial wasn't bumped and nothing is blocking the vents inside. With the fridge unplugged, look at the condenser coils at the bottom or back; if they are gray with dust, vacuum them. Our guide to a refrigerator not cooling with the light on walks through more checks.
Cold air for the fridge comes from the freezer. When frost covers the evaporator coil, the evaporator fan fails, or the air damper sticks closed, the freezer stays cold while the fridge warms up. Frost on the coil usually means a failed defrost heater, defrost thermostat, or control.
Check first: Open the freezer and look at the back panel. A thick layer of frost or ice points to a defrost problem. Press the door switch and listen for the fan. Unplugging the fridge for a day with the doors open melts the frost and often brings the cooling back, but if the problem returns within a week, a defrost part has failed.
Water under the crisper drawers usually means a clogged defrost drain. A puddle on the floor can come from a cracked drain pan, a loose or split water line to the ice maker, a bad water inlet valve, or a filter that isn't seated.
Check first: Note where the water collects. Reseat the water filter, then pull the fridge out and look at the supply line and the valve at the back. If the water is inside the fridge, the drain is the likely cause; a clog often comes back, so it is worth having the drain cleared properly.
Common causes are a frozen fill tube, a failed water inlet valve, a clogged filter, low water pressure, a freezer that runs too warm, or a worn ice maker assembly.
Check first: Make sure the ice maker is switched on and the shutoff arm is down. Check that the freezer is near 0°F and that water comes out of the dispenser. If the filter is more than six months old, replace it. More on our ice maker repair page, or read our guide for when a Sub-Zero isn't making ice.
A clicking or scraping sound from the freezer is often the evaporator fan blade hitting ice. A buzz or rattle at the bottom back comes from the condenser fan, the compressor, or a loose drain pan.
Check first: Find where the noise comes from. Make sure the fridge is level and isn't touching the wall or the cabinets. If the noise is inside the freezer and you see ice around the fan cover, the defrost system needs attention.
Dirty condenser coils, a torn door gasket, a defrost problem, a failing temperature sensor, or low refrigerant can keep the compressor running all the time.
Check first: Close the door on a dollar bill. If it slides out easily, the gasket isn't sealing. Leave an inch or two of space behind the fridge and clean the coils; our coil cleaning guide shows how. A fridge that has just been loaded with groceries or sits in a hot garage will run longer, which is normal.
Unplug the fridge before you touch the coils or remove any cover. If these checks don't solve it, book a diagnostic and we'll find the part that actually failed.
The sealed system is the compressor, the condenser, the evaporator, and the refrigerant lines between them. When it fails, the fridge runs, but neither section gets cold, or the compressor clicks on and off every few minutes.
Many fridges that seem to need a new compressor actually have a bad start relay, a stopped condenser fan, or a control board fault. These parts cost far less, so we test them first. If the compressor or a refrigerant leak is the cause, the repair means opening the system, replacing the failed part, and recharging it with refrigerant.
A compressor replacement typically costs $620 to $1,360 in Los Angeles. On a standard fridge older than about 10 years, that can come close to the price of a new one. On a built-in model like a Sub-Zero, the repair is usually the better choice.
| Common repair | Typical cost |
|---|---|
| Not cooling (fan, relay, or sensor) | $250 to $470 |
| Defrost system failure | $280 to $460 |
| Water leak or clogged drain | $200 to $370 |
| Control board | $340 to $570 |
Typical repair cost in Los Angeles; exact price after the $65 diagnostic, which goes toward the repair.
Most fridge repairs are worth doing, especially on built-in and premium models. A simple rule helps with the rest: if a repair costs more than half the price of a comparable new fridge and yours is near the end of its life, replacing it usually makes more sense. Our repair or replace guide explains the 50% rule and how long fridges last.
Wondering what other repairs cost? See the typical prices in our refrigerator repair cost guide.
“Stan from Appliance Insight did an incredible job fixing my GE Monogram Refrigerator. […] He took the time to properly diagnose the problem, and got the part needed to repair my refrigerator. Now it’s cold and working perfectly!”
“Stan answered right away, arrived promptly the next morning, analyzed the problem as a malfunctioning control panel, set a reasonable price and fixed it the next day after ordering and getting the new part.”
“Stan arrived right when he said, on time and stayed working without break until he found and solved why my fridge broke. The diagnostic fee and repair fee was super reasonable.”
Read more on our reviews page.