KitchenAid Refrigerator Not Cooling in Playa del Rey: How We Fixed It

KitchenAid refrigerator not cooling right, or more like cooling all wrong, that's what a homeowner in Playa del Rey called us about. The temperatures had gotten unstable, the freezer too cold one minute, the fridge side too warm the next, and they wanted somebody to figure out why. We're based in West Hollywood, but we come out to the coastal neighborhoods a lot, so we headed down.

What the Customer Noticed

The refrigerator had started acting up in a few ways at once. The freezer was swinging between 0°F and minus 10°F, the fresh food side was warming up to 48°F, the compressor was running nonstop, and hardly any cold air was making it into the fridge compartment. On a KitchenAid that combination usually points to the airflow control or a main board that's starting to fail.

What Stan Found

Once Stan got into it, there were really three things going on. First, the air damper was stuck completely closed. That's the flap that lets cold air from the freezer into the fridge side, so with it shut the upper compartment climbed to 48°F even though it was set to 37°F. Second, the freezer was over-cooling, dropping to minus 10°F while set to 0°F, which told us the controls weren't regulating the cooling cycle. And third, the condenser coil was caked with dust, so the compressor had to run constantly and the temperatures got even more out of balance. Three problems feeding each other, basically.

The Repair

Stan swapped in a new main control board, and while he was at it he cleaned the condenser coil properly, which honestly should be done every six months or so anyway. Then he reset the cooling cycle, let it settle and checked the airflow and the readings again to be sure.

The Result

Once it all settled, the freezer sat at 0°F, the fridge held 37°F, and the compressor was going on and off like it's supposed to instead of running all day. No more swings.

If yours is doing something like this, temperatures all over the place, freezer too cold, fridge too warm, or it just never stops running, give us a call at (213) 761-5757. Call before 11 AM and there's a good chance we can come the same day, the diagnostic is $65 and it comes off the bill if you go ahead. We're based in West Hollywood and cover Playa del Rey, Marina del Rey, Venice, Westchester and the rest of the Westside, and there's more on built-in and freestanding models on our KitchenAid repair page.