Why Is My Dishwasher Leaking? A Guide by Where the Water Shows Up

Where the water shows up is the best clue to why a dishwasher leaks. A puddle at the bottom of the door usually means a seal or suds problem you can often fix yourself. Water that spreads from underneath the machine, or a damp cabinet under the sink, points to a hose, a valve or a pump seal. Below we go spot by spot: the likely causes, what an owner can safely check and when it's time for a technician.

First: stop the water and find the source

Even a small leak is worth dealing with quickly. Water can soak into the subfloor and the cabinet next to the dishwasher, and in an apartment building it's often the downstairs neighbor who finds it first. There is also wiring and a control board under the tub.

  • Turn off the power. Whirlpool and Samsung both say to switch the dishwasher off at the breaker if water is visible. Don't reach under a wet machine with the power on.
  • Shut off the water. The supply valve is usually in the cabinet under the sink.
  • Dry everything. Soak up the water with towels or a wet/dry vacuum, so you can see where new water comes from.
  • Make sure it's the dishwasher. A dripping sink trap, a leaking faucet or a spill from the counter can look the same on the floor.

To find the spot, wipe the area dry, put a dry paper towel on the floor along the door and under the sink connections, and run a short cycle while you watch. LG suggests the same trick for its connections. Where the paper gets wet first is where you start.

Leaking from the bottom of the door

This is the most common place, and the most common causes are easy to check.

  • Door gasket. The rubber seal around the tub can be dirty, twisted, torn or pulled out of its channel. Wipe it with warm soapy water and an old toothbrush, push it back into place and look for cracks. A gasket that is torn or flattened needs to be replaced.
  • Too many suds. Regular dish soap makes a wall of foam that pushes out past the door. GE adds that too much dishwasher detergent or spilled rinse aid can do the same. Use dishwasher detergent only, one pod or tablet at a time.
  • Unlevel dishwasher. If the machine tilts forward or to one side, water runs to the door and the door doesn't close squarely. Whirlpool and LG both put leveling high on their lists. Put a level on the top front edge and adjust the feet.
  • Dishes in the way. A large pan or a baking sheet can deflect the spray straight at the door. Blocked spray arm holes do the same. Check that the arms spin freely and the holes are clear.
  • Door latch or hinges. A loose latch or worn hinge springs let the door sit slightly open at the bottom. If the door doesn't close firmly, that needs a repair.

If the leak only shows up at the door corners, look at the gasket ends at the bottom of the door and at the leveling first.

Leaking from underneath the dishwasher

Water that comes from under the machine, with a dry door, usually comes from inside the base. Owners can't see these parts without pulling the dishwasher out.

  • Pump or sump seal. Whirlpool lists worn pump, diverter and motor shaft seals for leaks at the bottom front center. This often starts as a slow drip during the wash.
  • Water inlet valve. A cracked valve, or one that doesn't close fully, leaks during the fill or even while the dishwasher is off.
  • Float switch. The float tells the machine when to stop filling. If it sticks, the tub can overfill. Whirlpool suggests checking that it moves up and down freely. On many models it's a small cap on the floor of the tub, near the front.
  • Hoses inside the base. Internal hoses and clamps age and crack, especially in older machines.
  • Cracked tub. Rare, but on old dishwashers the tub itself can crack or rust through. That usually means replacing the dishwasher.

Many dishwashers have a leak sensor in the base pan. Bosch shows E15 when the safety switch finds water in the base, and its advice is to turn off the water and call for service. On LG models, AE points to a leak or overflow. If you see one of these codes, the water is already inside the machine.

Leaking from a front corner

The front left or right corner is a common spot because the water supply connection and the inlet valve often sit behind the kick plate on one side. LG names a loose 90-degree elbow fitting at the inlet as a cause of water at the bottom. A drip there usually shows up during the fill, at the start of the cycle.

What you can check: with the power and water off, take off the kick plate (usually two screws) and look with a flashlight for drips or mineral crust around the fitting and valve. Don't tighten a brass fitting hard, because it can crack. If the fitting or valve is wet, it's a job for a technician or a plumber.

A corner leak can also be a door problem. If the dishwasher is not level, water gathers at the low corner of the door.

Leaking under the sink

Two hoses run from the dishwasher to the sink cabinet: the water supply line, which connects to the shutoff valve, and the drain hose, which connects to the garbage disposal or the drain pipe.

  • Supply line. Check both ends with a dry paper towel during a fill. A slow drip at the shutoff valve or a corroded line needs a new connection.
  • Drain hose. KitchenAid points to a loose clamp or a worn hose. Check the clamp at the disposal or drain pipe, and look along the hose for cracks. A loose clamp can be tightened. A cracked hose should be replaced.
  • Air gap. Water spitting from the small cap next to the faucet means the air gap, or the drain line after it, is clogged. Pull off the cover and clean it. GE notes that water from the air gap, with no suds in the tub, is a plumbing issue.

If water only appears under the sink while the dishwasher drains, the drain path is the first place to look. Our dishwasher not draining guide covers clogged filters, air gaps and disposals in detail.

The timing of the leak is a clue too

When the water appearsMost likely cause
During the fill, at the start of the cycleInlet valve, supply fitting, float
During the washDoor gasket, suds, spray arms, pump seal
During the drainDrain hose, clamp, air gap, clogged drain
When the dishwasher is offInlet valve not closing, supply line
No water, only a musty smellA slow hidden leak under the machine

That last one is worth taking seriously. KitchenAid says a leak underneath may show no water at all, only a mold smell around the dishwasher.

What you can fix and when to call

You can safely handle the gasket, the detergent, the leveling, the spray arms, the air gap and a loose drain hose clamp under the sink. Call a technician when:

  • the leak comes from under the machine and the door is dry;
  • you see a Bosch E15, an LG AE or another leak code;
  • the inlet valve, a fitting or a hose inside the base is wet;
  • water keeps coming back after you fixed the gasket and leveling;
  • there is water near the wiring or the control board.

What a technician checks

We pull the dishwasher forward if needed, take off the kick plate and run a cycle with the base open. That way we can see the leak as it happens, at the inlet valve, the pump and its seals, the hoses and the door. We also check the leak sensor and any stored codes. The diagnostic visit is $65, and that amount comes off the bill if you go ahead with the repair. Every repair comes with a 183-day warranty on parts and labor.

Leak repair prices in Los Angeles

Here is what leak repairs typically cost in Los Angeles. The exact price comes after the $65 diagnostic, which goes toward the repair.

RepairTypical cost
Leaking (gasket, inlet valve, hose, pump seal)$230 to $400
Door latch$190 to $300

Some leak calls end with no new part at all: a fitting is resealed, a hose is reconnected or the dishwasher is leveled. Prices for other appliances are in our appliance repair cost guide. If your dishwasher is old and the tub is cracked, our repair or replace guide can help you decide.

If you're in Los Angeles, you can book dishwasher repair online. If you call before 11 AM, ask about same-day appliance repair. We work on all major brands, including LG, Bosch and Miele. For LG leak and overflow codes, see our LG dishwasher error codes guide.

How to keep the dishwasher from leaking

  • Use dishwasher detergent only, never dish soap, and don't add more than the dispenser holds.
  • Wipe the door gasket once a month.
  • Clean the filter and the spray arms regularly. Hard water clogs them faster, which our hard water dishwasher guide covers.
  • Keep big pans away from the door side of the rack.
  • Look under the sink every few months for drips or crust on the connections.

FAQ

Why is my dishwasher leaking from the bottom of the door?

The usual causes are a dirty or damaged door gasket, too many suds from dish soap or too much detergent, a dishwasher that isn't level, or a large dish deflecting the spray at the door. Clean the gasket, use dishwasher detergent only and check the leveling. If it still leaks, the latch or hinges may need a repair.

Why is my dishwasher leaking from underneath?

Water from under the machine, with a dry door, usually comes from a worn pump or sump seal, a cracked or stuck water inlet valve, a loose hose inside the base, or a float that lets the tub overfill. These parts are behind the kick plate, so a technician should check them.

Why is my dishwasher leaking from the bottom left or right corner?

The water supply connection and the inlet valve often sit behind the kick plate at a front corner, so a loose fitting or cracked valve shows up there during the fill. An unlevel dishwasher can also send water to one corner of the door.

Is it safe to use a leaking dishwasher?

It's better not to. Water near the wiring and control board is a shock and fire risk, and a slow leak can damage the floor and cabinets. Turn off the power at the breaker and the water under the sink until the source is found.

Why is my dishwasher leaking when it's not running?

If water appears while the dishwasher is off, the inlet valve may not be closing fully, or the supply line or its fitting under the sink is leaking. Shut off the water under the sink and have the valve checked.

What does E15 mean on a Bosch dishwasher?

Bosch says E15 means the safety switch found water in the base and the leak protection system turned on. Bosch advises turning off the water inflow and contacting service.

How much does it cost to fix a leaking dishwasher?

A dirty gasket, wrong detergent or loose drain hose clamp costs nothing to fix yourself. In Los Angeles, a leak repair typically costs $230 to $400. The exact price comes after the $65 diagnostic, which goes toward the repair.