RefrigeratorsOn a lot of French-door models the big one is the ice maker freezing up: ice builds up in the compartment up in the door and the ice just stops coming. Usually that's a door seal or a fan, sometimes the heater. Codes we see a lot are Er IF (ice maker fan), Er FF (freezer fan), Er dH (defrost isn't finishing, often because the evaporator iced over) and Er rS or Er FS (a temperature sensor). And if the display says OFF and nothing is cooling, it might just be stuck in demo mode, which shuts the cooling off on purpose. Worth a look before you call anybody, us included.
WashersOE means it couldn't drain, so check the pump filter first, it's behind the little door down at the bottom on front-loaders. IE is a fill problem, most of the time a closed valve, a kinked hose or a clogged inlet screen. UE is usually just an unbalanced load. LE has to do with the direct-drive motor, it means the motor locked up or couldn't turn the drum, and honestly that one we'd rather test than guess at, because it can be the motor, the rotor position sensor or just a load that was way too heavy. Oh, and if your front-loader smells, it's almost always the door gasket staying wet, so leave the door cracked open after the last load and wipe the boot now and then.
DryersYour LG dryer actually watches its own airflow, which is kind of great, so when you see d80 it's telling you the vent is about 80% blocked, d90 is around 90%, and at d95 it gives up, cools down and stops. People call us thinking the dryer died, but a lot of the time it's the vent, and a vent that packed with lint is a real fire hazard, so please get it cleaned out. If the air's moving fine and it still won't heat, then it's on us to check the element, or on a gas dryer the igniter and the valve coils, plus the thermal fuse. In Pasadena? Our
Pasadena dryer repair page lists the LG and Samsung dryer codes we see most.
DishwashersOn the dishwasher side, OE is a drain problem, IE means it isn't getting water in, and AE is the scary-looking one, it just means some water got down into the base and set off the leak sensor. Before calling, pull the filter and rinse it, run the garbage disposal if the dishwasher drains into it, and peek under the sink for a kinked hose. When it keeps coming back anyway, it's usually the pump, an inlet valve or a seal that's started to leak.
Ranges, ovens and cooktopsHere we get calls about ovens that take forever to preheat or can't hold a temperature, burners that click and click and never light, induction zones that just sit there blinking at you. On gas ovens the bake igniter gets weak as it ages and stops opening the gas valve, temperature sensors drift over time, and a burner that got splashed while cooking will keep clicking until it dries out, so we always rule out the cheap and simple stuff before anything else.